How To Fell a Leaning Tree In The Opposite Direction [Properly]

Spread the love

How To Fell A Leaning Tree In The Opposite Direction

Trees are amazing. They can provide your home with shade. And, they’re going to add a little something special to the scenery. However, they can also be very problematic. Trees tend to do a lot of damage when they fall. This is why you should think about cutting them down. Or, you might just want to cut a tree for the firewood. Whatever the situation might be, you’ll want to make sure that you cut it down in a safe manner. Otherwise, it might fall on your vehicle or property. So, how can you cut a leaning tree in the opposite direction? You’re about to find out.

Planning The Fall

First and foremost, you need to understand that felling any tree is going to be downright dangerous. Before you use your chainsaw to make notches in the tree, you need to look at your surroundings. Is the opposite direction really the best? Make sure that the tree is going to have a clear path to the ground. Otherwise, it might get caught in other trees or power lines. You should also have several escape routes. If something goes wrong, you need a way to get out of there.

Drawing Your Cuts

Now, you should think about your cuts. To fell a tree in a specific direction, you need to cut a notch on the side where you want it to fall. If you want a leaning tree to fall in the opposite direction, you would make the cuts on the side that isn’t leaning. Then, you would finish the cut on the opposite side. The highest point of the triangular notch should be placed a few inches beneath the back cut. This will create a hinge and stop the trunk from splitting. It will also decrease the risk of the trunk from moving when the tree falls. Make the appropriate marks on the tree.

Cutting The Notch

To cut the triangular notch, you’ll actually need to make two cuts. You should start with the top cut. Be sure that the saw is perpendicular to the trunk. When you begin cutting, the saw should penetrate a third of the trunk’s diameter once you’ve reached the line. Remember that the uppercut would be made at a 70-degree angle. The bottom one should be a 20-degree angle. It is vital to make sure that your two cuts are going to meet exactly. Otherwise, you’re going to have a “Dutchman” and that could cause the trunk to split when the tree falls to the ground.

Cutting The Opposite Side

Now, you’ll need to switch to the opposite side. The cut should be placed 2 to 5 inches above the highest part of the notch. Remember that the cut should be horizontal. Since you’re trying to get the tree to fall in the opposite direction, you’re going to need wedges. Make the cut in stages and use wedges to support the trunk. After the cut is halfway through the trunk, you should switch to the wedges and sledgehammer.
Knock the wedges deeper into the tree with a sledgehammer and it’ll fall in the direction that you prefer.

About the author

easierhomesteading.com are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites